Covering Stowmarket and the surrounding area Monday to Friday 0900 to 1700 Request a call-out

Sonde & Tracing in Long Melford - The Full Job Process From Arrival to Completion

Knowing what actually happens during a sonde and tracing visit in Long Melford helps you prepare your property and understand what you're paying for at each stage.

Est. 2025 Told what it will cost before we start You see what was wrong Cleared up before we leave
Sonde & Tracing - work in progress

When the engineer arrives, the first step is a walk-round of the property to identify all visible drainage features: manholes, inspection chambers, gullies, and any pipe entry and exit points on the building. This takes a few minutes but shapes the whole survey, because it determines where the sonde transmitter can be inserted and which direction to work from. The transmitter is then fed into the drain at the best available access point. As it travels through the pipe, the engineer moves above ground with a receiver, pausing at intervals to take a depth reading and mark the pipe's position on the surface with chalk or a marker pin. The result is an accurate plan of the pipe's route.

If the transmitter cannot pass a certain point - because of a blockage, a collapsed section or a tight bend - that point itself is a significant finding. The depth and position of the obstruction is logged. Where CCTV is run as part of the same visit, the camera confirms what the obstruction consists of. After the survey, the engineer compiles the findings into a written report with the marked positions noted and, where CCTV was used, relevant still images or footage. Any subsequent excavation is then targeted precisely at the confirmed fault position. Reinstatement of the excavated area - backfill, compaction, any surface dressing - forms the final stage, and the site is left clear before the job is signed off.

What you get

  • Chambers lifted and the run checked, so the work starts from what is actually happening rather than from the symptom.
  • The blockage cleared with the right tool for the pipe: rods, a machine or the jetter, chosen so the pipe is not damaged getting through it.
  • The cause looked for once it runs, on camera where it is not obvious from the chamber.
  • What we found explained in plain words, with stills or footage if you want them.
  • The area washed down and the covers back properly before we leave.

Sonde & Tracing in Long Melford?

Ring and speak to the engineers who will be doing the work, or send the form with the postcode and what is happening.

Call Call-out